nuwavenow.com | 9
ASSEMBLY GUIDE
Note: Do not leave Dome
in Dome Holder for an
extended period of time.
1. Make sure the Power Head is
tightly locked onto the Dome.
2. Place Dome Holder under
either side of Base handle.
3. Make sure both feet of the
Dome Holder are situated
inside the handle, and the
Dome Holder is resting
horizontally on a at surface.
4. Place the assembled Power
Head and Dome at a 45°
angle on the holder as shown
in the larger photo below.
DOME HOLDER
Setup Instructions
To Next Page
Loading...
