MEC 5000, 6500 & 8000/P | 25www.natvac.com | 800.253.5500
8. Coat the housing and vanes
with oil and install the vanes
in the rotor. The vanes should
slide freely in the vane slot.
9. Locate the replacement seals and install them
in the endplate with the seals positioned back to
back.
10. Lubricate and install the bearing in the endplate.
11. Locate the proper number of
gaskets and install them on the
endplate.
Do not use any gasket sealer.
Locate the two 10x50mm bolts
used for pulling the endplate and
insert them in bolt holes on either
side of the endplate to capture the
gasket.
To Next Page
Loading...