MEC 5000, 6500 & 8000/P | 27www.natvac.com | 800.253.5500
15. At this point you should be
able to turn the pump by hand.
16. Reinstall the oil pump drive key
and oil pump mount assembly
to the pump.
Be sure to line up the oil pump
drive key and the oil pump shaft
prior to tightening the assembly to
the pump.
17. Connect the oil lines to the oil
pump.
The pump is now ready to run.
18. Start the pump at a slow RPM and allow to run
for a few minutes until oil can be seen in the
lines.
The pump is now ready to go to work.
To Next Page
Loading...