Nvidia ConnectX-6 Lx - Page 26

NVIDIA ConnectX-6 Lx Ethernet Adapter Cards for OCP Spec 3.0 User Manual 25
1. Using the torx tool type listed in the below table, remove the screws according to
the instructions per OCP 3.0 bracket type.
Internal Lock Bracket
Pull-tab (Thumbscrew)
Bracket
Ejector-Latch Bracket
2. Gently separate the bracket from the OCP 3.0 card.
Internal Lock Bracket Pull-tab Bracket Ejector-Latch Bracket
3. Save the two screws.
Installing the New Bracket
1. Assemble the new bracket onto the card.
Important
Be careful not to put stress on the LEDs on the adapter card.