Nvidia ConnectX-6 Lx - Page 28

NVIDIA ConnectX-6 Lx Ethernet Adapter Cards for OCP Spec 3.0 User Manual 27
Internal
Lock
Bracket
Pull-tab
Bracket
Ejector-Latch Bracket
OCP 3.0 Adapter Card Installation Instructions
This section provides detailed instructions on how to install your adapter card in a
system. The OCP 3.0 adapter card is shipped assembled either with an internal-lock, a
pull-tab (thumbscrew), or an ejector-latch bracket. Follow the below instructions
depending on the card you have purchased.
1. Before installing the card, make sure that the system is off and the power cord is
not connected to the server. Please follow proper electrical grounding procedures.
2. Open the system case.
3. Align the card with the system rails.
Internal Lock Bracket
Pull-tab (Thumbscrew)
Bracket
Ejector-Latch Bracket
Warning
The following figures are for illustration purposes only.