20
Problem: When the system is starting up, there is a series of prolonged beeps.
Solution:
The VGA card may not be firmly inserted into the expansion slot. Ensure that the
gold-striped bus connector of the graphics card is properly inserted into the expansion
slot. Ensure this by pressing the card gently and evenly into the slot. Alternatively,
remove the card and re-insert it.
Problem: Monitor display flickers after Windows 95 or Windows 98 starts.
Solution:
Your monitor may not support the resolution or refresh rate that you have set. You
must use display settings supported by the monitor. To change the display settings:
(1) Restart your system in Windows 95/Windows 98 Safe mode. To do so:
a. Restart your system and when the message "Starting Windows 95/98…"
appears, press F8. A list of options including Safe Mode and Command
Prompt Only Mode appears.
b. Select Safe Mode and press ENTER.
(2) Lower your monitor's resolution.
For the resolutions supported by your monitor, refer to its manual.
To Next Page
Loading...
Need help?
General
