Jetson Nano Developer Kit DA_09402_001_01 | 14
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Warning: The FCC requires that you be notified that any changes or modifications
to this device not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
Underwriters Laboratories (UL)
UL listed Product Logo for Jetson Nano Developer Kit, model name P3450.
UL Recognized Component Logo for Embedded System Module for Jetson Nano, model
number P3448
CANADA
Innovation, Science and Economic Development Canada (ISED)
CAN ICES-3(B)/NMB-3(B)
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General
