1.
2.
3.
4.
5.
OCP 3.0 Bracket Replacement Instructions
Unable to render include or excerpt-include. Could not retrieve page.
OCP 3.0 Adapter Card Installation Instructions
This section provides detailed instructions on how to install your adapter card in a system.
Cards with Thumbscrew (Pull-tab) Bracket
Before installing the card, make sure that the system is off and the power cord is not connected
to the server. Please follow proper electrical grounding procedures.
Open the system case.
Align the card with the system rails.
Push the card until connectors are in full mate.
Turn the captive screw clockwise until firmly locked.
Please note that the following figures are for illustration purposes only.
To Next Page
Loading...
