9. Connect the wires to the amp and subwoofer (make
sure the amp is off rst).Make sure the polarity (+add-)
is correct.
10. Connect the RCA’s to the amp.
11. Double check the amplier controls at this time. Make
sure everything is set correctly for your system.
12. Now you’re ready to play it for the rst time. It is best
to leave the gain all the way down at rst. Start with the
head unit volume low and work your way up.
13. Now you can tune the amp. Take your time and make
only one adjustment at a time. It may take some time to
get the system fully adjusted. During this time the amp
is drawing current from the battery. You should check
the battery voltage from time to time and re-charge it if
it gets low. That’ s it. You’re done. Now have fun.
INSTALLATION CONT.
To Next Page
Loading...
