Need help?Do you have a question about the NVX JAD900.5 and is the answer not in the manual?
Details the technical specifications of the JAD900.5 amplifier, including RMS power, dimensions, and frequency response.
Information regarding CEA-2006 compliance for power output and signal-to-noise ratio.
Provides recommendations for selecting a suitable location and securely mounting the amplifier in a vehicle.
Details the proper procedure for connecting power, ground, and speaker wires to the amplifier for safe operation.
Explains different connection methods including line level inputs, 5-channel mode, and bridge mode operation.
Describes the function of the power and protection LEDs and what they indicate about the amplifier's status.
Explains the use of various controls like level, HPF, LPF, and subsonic filters for audio tuning.
Details the function of input sensitivity, source selection, and channel mode switches for proper setup.
Guides users on diagnosing problems related to the power LED and lack of audio output.
Addresses issues indicated by the protection LED, including thermal shutdown and short circuit protection.
Helps resolve common audio problems like alternator whine, ground noise, and reduced bass response.
Provides essential safety advice regarding hearing protection and jump-starting procedures.
Outlines the terms and duration of the limited warranty for the NVX product.
Explains the steps required to obtain warranty service or repair for defective merchandise.
Lists conditions and damages that are not covered under the product's limited warranty.
Information on obtaining warranty service through international dealers or distributors.
General| Channels | 5 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Signal to Noise Ratio | >90dB |
| Bass Boost | 0-12dB |
| Low-Pass Crossover Frequency | 50-250 Hz |
| RCA Inputs | Yes |
| Speaker Level Inputs | Yes |
| Preamp Outputs | Yes |
| CEA-2006 Compliant | Yes |
| Input Sensitivity | 200mV-6V |
| Crossover | Variable |
| Minimum Impedance Unbridged | 2 Ohms |
| High-Pass Crossover Frequency | 50-500 Hz |
To Next Page
