NXP Semiconductors FRDM-MCXN947 - Page 24

NXP Semiconductors
UM12018
FRDM-MCXN947 Board User Manual
Pin
number
Device pin /
GPIO
Function / Signal name Resistor setting Potential conflict
15 P2_6 PWM1_A0 - SD card connector (J25) pin 2
(SDHC0_D3)
16 P5-9V_VIN - - -
Table 19. Arduino compatible header J3 pinout...continued
Pin
number
Device pin /
GPIO
Function / Signal name Resistor setting Potential conflict
P4_12 RSHUNT_CURA_P SJ25 Pin 1-2 selection
(default setting)
FlexIO header J8, pin 17 (P4_12/
FXIO_D20)
1
P0_21 TSI0_CH16 SJ25 Pin 2-3 selection -
2 ADC0_A0 ARD_A0 - -
OPAMP0_
INN
RSHUNT_CURA_N SJ24 Pin 1-2 selection
(default setting)
-3
P0_20 TSI0_CH15 SJ24 Pin 2-3 selection Pmod connector J7 pin 2 (P0_
20/PMOD_INT)
4 ADC0_B0 ARD_A1 - -
P4_16 RSHUNT_CURB_P SJ23 Pin 1-2 selection
(default setting)
• USB VBUS power control
(USB1_OTG_PWR)
• FlexIO header J8 pin 21 (P4_
16/FXIO_D24)
5
P0_18 TSI0_CH13-HDR SJ23 Pin 2-3 selection Pmod connector J7 pin 5 (P0_
18/PMOD_FC0_SPI_MISO)
6 P0_14 ARD_A2 - Arduino J2 connector pin 3 (P0_
14/ADC0_B14-MC_BEMF_B
through the resistor SJ19 Pin 2-3
selection)
OPAMP1_
INN
RSHUNT_CURB_N SJ22 Pin 1-2 selection
(default setting)
-7
P0_4 TSI0_CH8 SJ22 Pin 2-3 selection • Camera connector J9 pin
17 (P0_4/EZH_CAMERA_
VSYNC)
• Pmod connector J7 pin 6 (P0_
4/PDM0_CLK through the
resistor SJ12 Pin 2-3 selection)
8 P0_22 ARD_A3 - Arduino J2 connector pin 5 (P0_
22/ADC0_A14-MC_BEMF_C
through the resistor SJ18 Pin 2-3
selection)
P4_20 RSHUNT_CURC_P SJ21 Pin 1-2 selection
(default setting)
FlexIO header J8 pin 25 (P4_20/
FXIO_D28)
9
P0_5 TSI0_CH9 SJ21 Pin 2-3 selection • Camera connector J9 pin 15
(P0_5/EZH_CAMERA_PCLK)
Table 20. Arduino compatible header J4 pinout
UM12018 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
24 / 41