NXP Semiconductors FRDM-MCXN947 - Connectors

NXP Semiconductors
UM12018
FRDM-MCXN947 Board User Manual
J18
J19
J15 (DNP)
J24
J26 J25 J27 J28
(DNP)
J22 J21
Figure 4. FRDM-MCXN947 jumpers
1.5 Connectors
Table 2 describes the FRDM-MCXN947 connectors. The connectors are shown in Figure 3.
Part
identifier
Connector type Description Reference section
J1 2 x 8 pin header
J2 2 x 10 pin header
J3 2 x 8 pin header
J4 2 x 6 pin header
Arduino compatible I/O header (outer rows) and
FRDM header (inner rows)
Section 2.9
J5 1 x 8 position receptacles mikroBUS socket connector Section 2.11
J6 1 x 8 position receptacles mikroBUS socket connector Section 2.11
J7 2 x 6 header (DNP) Pmod connector Section 2.13
J8 2 x 14 pin header FlexIO header for LCD screen connection Section 2.10
J9 2 x 16 pin header Used for connecting a camera Section 2.12
J10 2 x 2 pin header Connects to the CAN bus and allows external
connection with the bus
Section 2.5
J11 USB Type-C connector USB1 high-speed connector Section 2.3
J12 SDHC connector (DNP) To connect an external SD card Section 2.7
Table 2. FRDM-MCXN947 connectors
UM12018 All information provided in this document is subject to legal disclaimers. © 2024 NXP B.V. All rights reserved.
User manual Rev. 1 — 20 January 2024
6 / 41