Nyce NCZ-3014-HA User Manual

GARAGE DOOR (TILT) SENSOR
INSTALLATION GUIDE
STEP 1: INSTALL BATTERY
Slide open the Garage Door
Sensor’s top housing. Install the
CR2032 battery in the housing top
as shown below.
STEP 2: JOIN THE NETWORK
Users:
Refer to the instructions on your web portal or
smart phone application to join and configure the
Garage Door (Tilt) Sensor.
Developers:
Refer to NYCE’S “ZigBee Device Messaging
Specification” document for details on how to join
the Garage Door (Tilt) Sensor to the ZigBee
network.
This document can be found on NYCE’s Website
Support page: www.nycesensors.com/support/
STEP 3: PROPER DEVICE ORIENTATION
Mount the Garage Door Sensor on a horizontal pane of the garage door.
The Sensor should be mounted on the top pane (fully closed) or bottom
pane (fully open), depending on the desired operation. A pair of
sensors can be used on both bottom and top panes for full garage door
reporting, if desired.
Ensure that the Garage Door Sensor is oriented with the bar symbol
vertical, parallel to the edge of the garage door, as shown in the
diagram below on the left.
INCORRECT ALIGNMENT
CORRECT ALIGNMENT
Button
Garage Door Sensor
Right edge of Garage Door
Right edge of Garage Door

Nyce NCZ-3014-HA Specifications

General

Brand	Nyce
Model	NCZ-3014-HA
Category	Accessories
Language	English

Summary

Install Sensor Battery

Install CR2032 Battery

Slide open sensor housing and install the CR2032 battery.

Connect to Zigbee Network

User Network Join Instructions

Follow web portal or app instructions to join and configure the sensor.

Developer Network Join Details

Refer to NYCE's ZigBee Device Messaging Specification.

Proper Device Orientation

Mounting Location and Alignment

Mount on top or bottom pane, ensure bar symbol is vertical to door edge.

Install Sensor Housing

Bottom Housing Installation Methods

Install bottom housing using 2-sided tape or screws on a clean surface.

Installation Notes

Avoid metal surfaces, install in dry locations away from moisture.

Install Sensor Top Housing

Final Sensor Assembly

Insert top housing after confirming device communication.

Product Function and LED Indicators

LED Indicator Guide

Details on button presses, LED actions, and status descriptions.