Oase biOrb CLASSIC User Manual

- EN -
17
PRODUCT DESCRIPTION
• Check that the delivery scope is correct, complete
and undamaged.
 A
biOrb CLASSIC / FLOW / CUBE / LIFE / TUBE
1
Lighting unit with connection cable and ON/OFF
switch*
2
Cover insert
3
Bubble tube
4
Air hose with integrated non-return valve
5
Filter unit
6
Aerator pump with connection cable
7
Plug-in transformer
8
Bag with Water Conditioner and/or Biological Booster
9
Ceramic substrate**
10
biOrb aquarium operating manual
11
Lighting unit operating manual*
*Supply and version are product-specific.
**Quantity is product-specific.
WARNING
Danger of suffocation.
Keep plastic bags and small parts out of reach of babies
and young children.
Intended use
biOrb CLASSIC / FLOW / CUBE / LIFE / TUBE may only
be used as follows:
• As an aquarium.
The supplied components may only be used for the bi-
Orb products as specified in the following:
• The aerator pump: For aeration and supplying oxy-
gen to the aquarium.
• The lighting unit: For lighting the aquarium.
• The plug-in transformer: For connecting the aerator
pump and lighting unit to the mains.
• Operation under observance of the technical data.
The following restrictions apply to the aquarium and
its components:
• Only operate with water at a water temperature of
+4 °C to +35 °C.
Function description
Aquarium with LED lighting, filter unit and external
aerator pump for circulating the water.
INSTALLATION AND CONNECTION
Setting up the aquarium
How to proceed:
• Carefully unpack the acrylic aquarium.
• Do not expose to direct sunlight.
• For indoor use only.
• Do not move the aquarium when it is filled.
• Do not place on or near electrical devices.
• Do not place on or near heat sources.
• Operation under observance of the technical data.
Fitting the filter unit
How to proceed:
• Remove the packaging from the filter medium.
 B
1. Release the bubble tube from the filter housing by
a quarter turn counterclockwise (bayonet closure)
and lift out.
2. Place the bubble tube onto the filter cartridge and
fasten the bubble tube by a quarter turn counter-
clockwise.
3. Insert the bubble tube into the aquarium and fasten
it to the filter housing by a quarter turn clockwise.
Using the ceramic substrate
NOTE
Remove the packaging from the filter medium. Thor-
oughly rinse the ceramic substrate with warm tap wa-
ter before using for the first time to remove any soil-
ing.
NOTE
• Do not use aquarium gravel as it could clog the filter
cartridge.
• Only use the ceramic substrate provided.
• Do not tip the ceramic substrate into the aquarium
from a height as it could scratch the acrylic.
• Only use ceramic substrate particles that are at least
pea-sized. Remove and dispose of any particles that
are smaller.
How to proceed:
 C
• Wash and then place the supplied ceramic substrate
carefully into the aquarium and arrange it around
the filter housing.

Oase biOrb CLASSIC Specifications

General

Volume	30 L
Power source	DC
Water filter	Yes

Weight and Dimensions

Width	400 mm
Height	420 mm
Weight	3610 g