EasyManuals Logo

Oase FiltoClear 12000 User Manual

Oase FiltoClear 12000
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
21
- GB -
The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
Only operate the unit if no persons are in the water!
The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
Keep the socket and power plug dry.
Symbols on the unit
The warning symbols on the unit have the following meaning:
Risk of personal injury if used incorrectly
Incorrect use of the unit can cause injury or damage to assets. Always read the instructions for use first.
Risk of personal injury caused by a general source of danger
Dangerous UVC radiation. Health hazard for eyes and skin caused by light flash. Only operate the UV-C
lamp inside the housing.
The symbols on the unit relating to its use have the following meaning:
Protected against touching dangerous components. Splash water protected.
Protect from direct sun radiation.
Dismantle at temperatures of 0 °C and below.
Installation
Figure (A)
To be taken into consideration for planning:
Spacing between unit and water: min. 2 m (safety spacing!).
Do not expose the unit to direct sun radiation.
Water return point. OASE recommend: Route the return hose such that the clean water is indirectly returned to the
pond, e.g. through a water course. In this manner it will be additionally enriched with oxygen.
Height difference between filter lid and water return point: max. 2 m.
Installation possibility 1: Bury close to the pond.
Dig a hole close to the pond and place the container into the hole up to the mark (B 11).
Installation possibility 2: Placement close to the pond.
Place the unit close to the pond where it is flood protected (e.g. hidden behind shrubs). The ground must be firm and
level.
Connecting a filter pump
A filter pump is required to operate the pressure filter (only contained as a set in the scope of delivery). Only connect to
the pump by means of pressure hoses approved for at least 0.2 bar or the maximum pump pressure.
Hoses with an internal diameter of 1 1/2" or 2" can be connected to the unit.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oase FiltoClear 12000 and is the answer not in the manual?

Oase FiltoClear 12000 Specifications

General IconGeneral
UV ClarifierYes
UVC Power36 W
Suitable for Ponds up to12000 liters
Filter Volume60 liters
Suitable for Ponds with Fish6000 liters
Suitable for Ponds with Koi3000 liters

Related product manuals