Oase FiltoClear 30000 User Manual

- EN -
24
Commissioning/start-up
NOTE
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
OASE recommends the use of BioKick (OASE filter starter bacteria):
– For the initial start-up
– After manual cleaning of the foam filters
– After fitting new foam filters
– When recommissioning following a storage period/over-wintering
Prior to using filter starter bacteria ("Filter starter"), operate the unit for approx. 24 hours without switching on the UVC
unit. If you do not use filter starter bacteria, commissioning can start directly with the "Fitting connections" step.
How to proceed:
• Open the container (Cleaning and maintenance\Opening the container).
• Fill the filter starter bacteria (adhere to the attendant instructions for use!).
• Close the container (Cleaning and maintenance\Closing the container).
• Fit the connections ( Assembly).
• Check the firm seating of hoses, cover cap for soiled water drain, clamping ring with safety latch.
• Turn the function switch (J 5) to water filtering (40), if it is not already in this position.
• Switch on the pond pump.
• Only switch on the UVC unit when water is flowing through it. You may have to wait for 24 hours.
Connect power plug to the socket. The UVC unit switches on immediately, the blue LED (J 33) is lit.
Operation
The unit is no longer biologically active at water temperatures below 10 °C. Take the unit out of operation at water tem-
peratures below 8 °C or, at the latest, when freezing temperatures are to be expected.
Normal operating condition: The UVC unit is switched on. The UV-C lamp must be replaced after approx. 8000 operat-
ing hours.
Remedy of faults
Malfunction
Cause
Remedy
No water flow through the re-
turn socket.
− Filter pump not switched on.
− Switch on the filter pump
− Supply lines blocked.
− Check supply lines
− Function switch not turned to "Filter water"
− Turn function switch to „Filter water“
UVC lamp display is not lit
− Connection defective or has not been made.
− Check connection (power plug, power fuse)
− Temperature monitor has switched off the UVC
lamp
− Allow the UVC lamp to cool down
− UVC lamp defective
− Replace UVC lamp
− Quartz glass tube not fitted
− Fit quartz glass tube
Filtering performance not satis-
factory
− Function switch not turned to "Filter water"
− Turn function switch to „Filter water“
− Unit has not been in operation long enough
− Wait a few days/weeks
− Water extremely soiled
− Excessive fish and animal population
− Adhere to the reference value
− Foam filters clogged
− Clean foam filters
− Quartz glass tube soiled
− Cleaning the quartz glass tube
− UVC lamp is in operation for more than 8000
hours
− Replace UVC lamp

Oase FiltoClear 30000 Specifications

General

UV-C Power	55 W
UV-C Clarifier Included	Yes
Suitable for Ponds up to	30000 liters
Filter Media	Foam
Suitable for Ponds with Fish	15000 liters
Suitable for Ponds with Koi	7500 liters
Cleaning Mechanism	EasyClean