Need help?Do you have a question about the Oase ProfiClear Premium Compact-L EGC and is the answer not in the manual?
General| Number of filter foams, red | 2 |
|---|---|
| Number of filter brushes | 2 |
| Connection for Bitron C | Yes |
| Connection for Bitron Eco | Yes |
| Guarantee | 2 years |
| Features | Integrated UV clarifier |
| Suitable for ponds with fish stock up to max. | 10, 000 l |
| Maximum Pond Size | 10, 000 l |
Explains hazard categories (DANGER, WARNING, CAUTION, NOTE).
Requirements for safe electrical installation and connection.
Warning about magnetic fields affecting pacemakers.
General rules for safe handling and use of the unit.
Specifies the approved applications and restrictions for the unit.
Details the configuration and advantages of a pump fed setup.
Details the configuration and advantages of a gravity fed setup.
Lists and describes all components of the system.
Explains how the mechanical and biological filtration works.
Information on smart control features and connectivity.
Safety instructions for moving the heavy unit.
Guidelines for positioning the unit and electrical safety.
Specific installation requirements for pump fed systems.
Specific installation requirements for gravity fed systems.
Instructions for connecting the main filter components.
How to connect water inlet pipes for pump fed systems.
Steps to install the UVC clarifier unit.
How to connect the outlet for coarse dirt removal.
How to connect the DN 75 dirt outlet for draining.
How to connect the control unit and EGC network.
Placement and mounting of the control system.
Instructions for connecting an aerator pump.
Step-by-step guide for starting a pump fed system.
How to calibrate the water level sensor.
Step-by-step guide for starting a gravity fed system.
How to configure pump status monitoring.
Identifies and explains the controller's buttons and display.
Procedure for powering the control system on and off.
Describes automatic, time-dependent, and manual cleaning modes.
How to initiate a cleaning cycle manually.
Overview of menu-based settings for the unit.
How to view cleaning cycle history.
Procedure to reset settings to factory defaults.
Explains error codes and their meanings/remedies.
Troubleshooting steps for lack of water flow.
Troubleshooting steps for reduced water flow.
Troubleshooting steps for cloudy water issues.
Diagnosing and resolving noises from the drum.
Troubleshooting when the filter drum is not cleaning properly.
Troubleshooting overflow in pump fed systems.
Troubleshooting for filter pump running dry in gravity fed systems.
Troubleshooting low flow rate issues.
Troubleshooting why timed cleaning isn't activating.
Troubleshooting when the control system display is blank.
General advice on cleaning the unit and recommended agents.
Routine checks and cleaning actions for optimal performance.
Procedure for deep cleaning the whole system.
How to clean the components responsible for rinsing the drum.
Instructions for cleaning the filter screen elements.
Steps to remove and reinstall the filter drum.
How to clean the rinsing pump.
Steps to replace the rinsing pump.
How to replace the aerator rod.
Guidelines for operating the unit in cold conditions.
Procedures for preparing the unit for winter shutdown.
To Next Page