Observint BC600 Series - APPENDIX A Troubleshooting

11
High Resolution Indoor/Outdoor IR CCTV Bullet Camera User Manual
APPENDIX A: TROUBLESHOOTING
APPENDIX A
Troubleshooting
Problem Possible Cause
Nothing appears on the screen - Check the power connection.
- Check the video signal cable connection to the monitor.
The video image is dim or not clear. - If the camera lens is dirty, clean it with a soft, clean cloth.
- Adjust the monitor controls, if necessary.
- If the camera is facing a very strong light, change the camera position.
- Adjust the lens focus.
The screen is dark. - Adjust the contrast control of the monitor.
- If you have an intermediate device, set the impedance (75  /Hi-Z) properly, and check the cable
connections.
The camera is not working properly and the
surface of the camera is hot.
- Verify that the camera is correctly connected to an appropriate regulated power source.
The MOTION DETECTION function is not working - Is “MOTION DETECTION” mode turned on?
- Check the setting of the MD AREA.
The image on the monitor ickers - Make sure that the camera isn’t facing direct sunlight or uorescent light. If necessary,change the camera
position.
Colors are not quite right. - Check the settings in the WHITE BAL menu.