10. DISPLAY AND FUNCTION KEYS
11. ASSEMBLING THE E-SCOOTER
- After removing the e-scooter from the packaging and checking that everything is compliant with
what is indicated in paragraph “8”, it is necessary to assemble the dismounted components.
a• Open the kickstand (2) and position
the e-scooter on a at surface.
b• Raise the handlebars stem (7).
c• Raise the locking lever (6) and push it
against the handlebars stem (7) until a
hooking “click” is heard.
d• Connect the two cables (the commu
-
nication cable between the display
board and the controller board).
Align the notch and connect the con-
nectors.
e• Insert the handlebars (9) on the han
-
dlebars bar (7).
Use the Allen wrench (e) to tighten the
screws (d) on both sides.
7
7
6
9
7
d
97
EN
To Next Page
Loading...