For correct operation of your ST500 it is critical to use SoundTrap Host version 3.3.1 or
later.
• Pre-installation Notes:
o The SoundTrap host software supports Windows 7,8 & 10 (32 or 64 bit versions).
o Do not connect the SoundTrap to your computer until you have completed the
SoundTrap host software installation.
o The installation will be smoother if you’re logged into windows as an administrator.
• Visit www.OceanInstruments.co.nz/downloads/ to download the software.
• Download and run the installer.
• Once the install completes, run the SoundTrap Host application.
2.5 Connect SoundTrap to your PC
• Connect the SoundTrap using the USB cable provided.
• The drivers will take a couple of minutes to install. Once complete you should see your
SoundTrap appear in the ‘Device List’ on the left, as shown in figure 1.
• Select your SoundTrap by clicking its label on the left.
Figure 1 - The Device List
To Next Page
Loading...
Need help?
General