Ocean Instruments SoundTrap ST500 - Begin recording using the IR Remote Control

2.8 Begin recording using the IR Remote Control
You may use the remote control to start recording. The
recorder housing must be open to receive the signal from the
remote.
• Press ‘START’ to start recording.
• Press ‘STOP’ to stop recording.
• If you have set a recording to start recording at a
later time, the recorder will blink red to indicate it
is ‘armed’ and waiting.
• The ‘armed’ state is cancelled by pressing Stop key.
• Re-enable the armed state by pressing the ARM
button.
• You can verify recording has started by checking for slow blinking of the status (green)
indicator.