o Options available in the ‘Audio Options’ will vary according to your device’s
capabilities. Options include the following:
▪ Channel Selection selects which channels to record on.
▪ Sample Rate should be set based on the frequency band of interest and
data rate considerations. A 96 kHz sampling rate is often a good choice for
general environmental noise measurements. Contact OI support if unsure.
o Detector – see HF Click Detector section below.
• Once you’ve made your selections click the deploy button which will save the settings and
you’re ready to go. The instruments internal clock is synchronised to your PC when you click
the deploy button. If you change your mind about something, just re-select the instrument
from the ‘Device List’.
To Next Page
Loading...
Need help?
General