Sauna & Steam
Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk
12
Sauna Heater Manual
8.3. Multi sauna heater linking function
8.4. Installing the controller
The controller must be installed on an outside wall, not inside the sauna cabin. Ideally the control
box should be installed at a height of approximately 1200mm for ease of use.
Installation method:
• Drill a 40mm diameter hole through the wall.
• Pull the front o the keypad, you may nd it easier with a small at electrical screw driver.
• Pin the control cable (6 cores) to the relevant ports.
• Install the control so it sits at on the wall. Fix using the screw holes 118mm apart.
• Put the keypad cover back on, check the cover is completely on so that all the buttons click
when pushed.
Fig 9
Fig 10
To Next Page
Loading...
