Oceanic OCS30 - User Manual

Questions and Answers

G
Gregory WaltersAug 3, 2025
Why does the Oceanic Heater temperature window display '--Lo' or '--Ho'?
- T
  Thomas KimAug 3, 2025
  The temperature window on your Oceanic Heater might display '--Lo' or '--Ho' due to several reasons: * If it displays '--Lo,' it could mean the temperature sensor isn't connected, the cable is broken, or the temperature is below 0°C. Check the connection and cable, or consider changing the sensor. * If it displays '--Ho,' it indicates a short circuit in the temperature sensor or that the temperature exceeds 115°C. Inspect the connection and cable, or replace the sensor. In some cases, you might need to change the controller.
S
stephanieolsonAug 9, 2025
What to do if the OverHeat LED is on in my Oceanic OCS30?
- J
  Jacqueline RossAug 9, 2025
  If the OverHeat LED is illuminated on your Oceanic Heater, it indicates a potential issue with the temperature sensor connection or the high-temperature cut-off switch. First, check the connection to the temperature sensor to ensure it is properly connected. Next, verify if the high-temperature cut-off switch is turned off; if it is, manually reset it.
G
garrett83Aug 14, 2025
What to do if the Oceanic sauna heater controller is on but the sauna heater doesn’t work?
- B
  Brandon MillerAug 14, 2025
  If the controller of your Oceanic sauna heater is on, but the heater isn't working, there could be a connection problem or an issue with the controller itself. First, check the heater's connection. If the connection is correct, you may need to replace the controller.
J
jennifer81Aug 21, 2025
What to do if the Oceanic Heater 'Wait' LED is red?
- M
  Monica ConwayAug 21, 2025
  If the 'Wait' LED on your Oceanic Heater is red, it means the sauna heater is in B mode. To resolve this, press the Mode button to switch to A mode, which is the heating mode.
R
Richard BrownAug 27, 2025
How to fix Oceanic OCS30 Heater when there is no display on the control panel?
- T
  tanya64Aug 27, 2025
  If there is no display on the control panel of your Oceanic Heater when you press the on/off switch, the issue might be with the power supply, the circuit board transformer, or the fuse. Begin by checking the power supply. If the power supply indicator LED L1 (red) is on, inspect the wire. If the power supply is not the issue, consider changing the controller.