EasyManua.ls Logo

Oceanic OCS B Series - Initial Testing and Operation; Pre-Operation Testing Steps

Oceanic OCS B Series
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sauna & Steam
Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk
16
Sauna Heater Manual
1. Switch o power during any maintenance, or tting electrical units.
2. Do not hang clothes to dry in the heater, for this may cause a risk of re.
3. Do not bake food in heater.
4. When it is hot, the outer surface of the heater may burn your skin.
1. Air supply vent
2. Optional air supply vent if mechanical exhaust ventilation is used, the opening is located 50cm
above the heater
3. Exhaust air vent
4. Drying vent, which is closed during heating and bathing, the sauna room can also be dried by
leaving the door open after bathing
5. If there is only an exhaust vent in washing room, leave an opening (MIN CM). Under the sauna
door (Mechanical ventilation is recommended)
9. Testing and Operation
9.1. 1. Testing
Before connecting to the power supply check the sauna heater and make sure there are
no ammable items on or around the heater, please note that on the rst use the elements and
Fig 15
Model Default Mode Default Temp
o
C/
o
F Temperature adjust scope
o
C
OC-SB
A 75
o
C 187
o
F 50-110
o
C 122-230
o
F
Default Time Time adjust scope
Working time Waiting Work time Wait time
2hrs 4hrs 10mins - 8hrs 0-12 hrs
Time adjustment per button press Temperature adjustment per button
press
10 mins 1
o
C /2
o
F

Related product manuals