Ocom OCPP-M05 - Button Operating Instructions

Button Operating Instructions
POWER（Green Light） FEED（Rad Light ）
Printer Status
OFF OFF Printer Close
ON（Always）
Off Printer open and have paper
ON(Always）
Flash Printer Open , without paper
ON（Always） ON（Always）
Printer have paper
Under the normal working status, the paper feeding begins when
press 【FEED】 button, and stop when loosen【FEED】 button.
the printer paper feed
Power off the printer, then hold down the【FEED】button and
press the power button at the same time. Wait 2 seconds ,then
loosen the【FEED】button,the current setting will be printed out.
The printer Self test
Power off the printer, then hold down the【FEED】button and
press the power button at the same time. Wait until the power
indicator &【ERROR】led are both on, and then 【ERROR】led goes
off, then loosen the【FEED】button, the language setting status
will be printed out.
Transformation in both English
and Chinese
Power off the printer, then hold down the【FEED】button and
press the power button at the same time. Wait until the power
indicator &【ERROR】led are both on, and then 【ERROR】led goes
out, after, 【ERROR】led goes on again ,then loosen the【FEED】
button, the density setting status will be printed out. (It has
three levels setting for printing density, it is a circle Low
levelMiddle levelHigh levelLow level…, Please switch the
density status by repeating operation presented above.)
Set printing density
Power off the printer, hold down the【MODE】button and press
the power button at the same time. Wait until the power
Hexadecimal printing