Width
: 142 mm or less
Height
: 50 mm or less
Once you've made sure that your glasses are the right size, insert the
eyeglass spacer into your Oculus Go headset to provide a larger
fi
t.
To insert the eyeglass spacer
:
1. Using your
fi
ngers, carefully remove the lens rings and put them to one
side:
Place your headset face down on a
fl
at, clean surface.
Hold the headset still with one hand, and pull upwards from the outer
edge of the lens ring until it comes loose. Repeat this step for the
other lens ring.
2. Remove the facial interface foam.
3. Insert the eyeglass spacer so that the glasses logo is towards
the top of your headset, and gently press the spacer in place.
When the eyeglass spacer is correctly set, it should not move or fall
out of the headset easily.
4. Re-insert the facial interface foam.
5. Using your
fi
ngers, carefully press the lens rings back in place until they
click.
To put on your headset with glasses
:
1. Loosen the side and top straps on your headset.
2. Starting from the front, put your headset on over the top of your glasses.
3. With the headset on your head, tighten the side straps and then the top
strap to secure the headset.
To take o
ff
your headset with glasses
:
1. Loosen the side and top straps.
2. With both hands, pull the headset forwards, then take it o
ff
.
Note
: If your glasses don't
fi
t in the headset or the lenses of your
glasses touch the Oculus Go lenses, we recommend taking o
ff
your
To Next Page
Loading...
Need help?
General
