OCULUS Go - Safety Instructions

7/5/2019 Getting Started with your Oculus Go | Oculus Support Centre
https://support.oculus.com/183135912238400/ 9/16
glasses while using your Oculus Go or considering using prescription
lenses.
The included lanyard is used to secure the Oculus Go controller to
your wrist during use.
To connect the lanyard to your Oculus Go controller:
1. Remove the battery cover of your controller by lightly pulling at the bottom
half of the controller until it comes loose.
2. Insert the packaged battery into your controller so that the positive end is
facing the bottom of the controller.
3. String the lanyard through the small hole at the bottom of the battery
cover.
4. Take the end of the lanyard that has been strung through the battery cover
and attach it to the small peg at the base of your controller.
5. Slide the battery cover back over the base of your controller.
6. Push fi rmly until the battery cover clicks in place.
7. Ensure that the lanyard is securely connected to the controller before
using.
Depending on the colour and whether they're solid or blinking, the
lights on your Oculus Go headset and controller will indicate the
Was this answer helpful?
Permalink
Yes No
How do I attach the lanyard to my Oculus Go controller?
Was this answer helpful?
Permalink
Yes No
What do the di ff erent lights mean on my Oculus Go headset
and controller?