LA715
11 User ManualP2640300
<TASTO> : Totalization through keyboard as soon as the stability has been reached
<STABIL> : Automatical totalization when the weight is stable
6.3.3 P-MIN Minimum weight threshold setting
In this phase it is possible to set a weight value meant as minimum threshold under which no totalization
operation and printing are done. In addition, under this threshold the relè are inactive.
Setting 0 as a value, the totalization and the printing can always be done.
6.3.4 Abil-P Rehabilitation of the printing mode selection
This parameter allows to rehabilitate the printing after three different conditions : the first one is the
passage through zero : after each printing, it is necessary to unload the scale in order to be able to print
again. The second one is a variation of weight: a simple variation of weight allows to print again. In the
end, no condition is necessary in order to print twice consequently.
The possible choices are :
<INSTAB> : Print after a variation of weight
<PASS-0> : Print after passing through zero on the scale
<SEMPRE> : Print in any case
6.4 LINGUA : Language selection
This parameter allows to choose the language used by the user for the visualization of the messages.
The possible choices are :
<ITALIA> : Selected language : Italian
<INGLES> : Selected language : English
6.5 M-FISC : Fiscal Memory Enabling
It is possible to enable or disable the Fiscal Memory device
<ON> It enables the fiscal memory
<OFF> It desables the fiscal memory
6.6 NPROG : Continuous or total progressiv number
6.7 NO-OFF : It enables/disables the key On/off
6.8 CALTAS : Calibration of the keyboard of capacity
7 SERIAL COMMUNICATION PROTOCOL
See the attached
To Next Page
Loading...