Odys Alpha X5 - Fault Code Description; Specification

54 55
EN EN
Specification
Technical parameters
Rated power 350W
Max. power 700W
Battery capacity 10200mAh
Max. speed About 20km/h
General range
50km
Charge time About 5.5hours
Rated voltage
36V DC
Max. input voltage 42V DC
Rated energy 367.2Wh
Physical parameters
Storage temperature
-20 °C ~ +45 °C
Operating temperature
-10 °C ~ +40 °C
Operating humidity
20 % ~ 90 % (40 °C)
Bearing humidity
20 % ~ 93 % (40 °C)
L × B × H (Vehicle)
1150mm×570mm×1187mm
L × B × H (After folding) 1150mm×570mm×530mm
Net weight 19kg
Load range 25kg-100kg
Body length 120cm-200cm
IP rating IPX5
Max.climbing ability 18%
Tire pressure 3.4 bar/340Kpa/50Psi
Maximum transmit power (Bluetooth)
Frequency 2.4000–2.4835 GHz
Maximum transmit power 8dBm
*Depending on environmental conditions (temperature, road conditions, etc.) and scooter
conditions (tyre pressure, payload mass, etc.)
Fault code description
Error Codes Reasons Solutions
E1
Display failure
Please timely contact after-sales
service for detection and repair.
E2/E3/E4/
E5/E6
Controller failure
Please contact customer service
in time for fault detection and
troubleshooting.
H3 Accelerator failure
1. Please check that the accelerator
is returned to its position,
otherwise it cannot run normally.
2. Please timely contact after-sales
service for detection and repair if
the accelerator wiring harness is
loose or damaged.
H4
Brake failure
1. Please check that the brake
lever is returned to its position,
otherwise it cannot run normally.
2. If the brake lever wire becomes
loose or damaged, please contact
after-sales service for inspection
and repair immediately.
H5 Motor failure
Please timely contact after-sales
service for detection and repair.