42 43
EN EN
Charge the scooter
The scooter is powered by a built-in battery. No installation is required.
Charge the battery when it is low. To charge the battery, plug the scooter
directly into a wall outlet using the supplied battery charger.
Fully charge the scooter before first use. This will take about 5.5 hours.
When the battery is fully charged, you will see a fully charged battery bar
on the display.
Open the rubber
flap
Insert the battery
charger into the
charging port.
Disconnect the battery
charger from the charing
port when charging is
completed, and put back
the rubber flap
1. Open the packaging box and
remove the inner holder. Take out
the user manual, battery charger,
and other accessories. Finally,
remove the scooter from the box.
3. Install the handlebar onto the
stem.
2. Put down the kickstand, and hold
up the stem until it is completely in
an upright position. Then push the
quick release lever inward to the
end.
4. Follow the number order as
illustrated to pre-tighten the four
screws with the included Allen key.
Make sure the handlebar is correctly
installed and then tighten the screws
thoroughly.
Assembly and installation
2
1
3
To Next Page
Loading...