CHARGING THE XV-7 Microlite II BATTERY
SETUP OVERVIEW RADIO CONTOL TRANSMITTER • BATTERY INSTALLATION
If the Radio Control Transmitter will not be used
or stored for extended periods of time, please
remove the batteries.
Please use 4 AA batteries.
Use the polarity markings
to install in the correct
orientation. Do not mix
different batteries or
battery types.
Unscrew the screw holding the battery lid to
the body. Then lightly pull the clip down to pull
the lid away from the transmitter body.
Insert 4xAA batteries into the battery compartment,
making sure to match the polarities. Then replace the
lid and firmly tighten the screw to secure the battery
compartment.
WARNING
CAUTION
NOTICE
1. Locate the battery compartment underneath the unit as shown in Figure A. Slide open the battery door and then
carefully disconnect the power cable underneath the XV-7 Microlite II as shown in the photo (Figure B). Do not pull the
battery by the wires as the wires may break off of the battery housing.
CAUTION: Battery may be hot if being disconnected right after use. If hot, then wait a few minutes to let the battery cool
down.
Please check the AA batteries routinely. If the AA
batteries are left within the Radio Control Transmitter,
potential leakage and/or corrosion may occur which can
damage the transmitter and create a fire hazard.
Install batteries into the radio control transmitter.
STEP 1
Set the XV-7 Microlite II unit to charge.
STEP 2
Turn on the unit then the radio control and pair them
together. Do this by pushing up the throttle stick quickly
up once, then back down again. You will know it is paired
as the unit will stop blinking and the lights will stay steady
on.
STEP 3
To Next Page
Loading...
Need help?
General
