Automatic Brightness Stabilization
Functional Tests
Perform the following tests to verify that the system is operating satisfactorily.
(Refer to the 9800 C-Arm Sub-system chapter of this manual for Functional Tests.)
1. System Boot
2. Make a fluoroscopic exposure.
WARNING: The following procedure generates live x-rays. Take appropriate precautions against
undue exposure.
Take several Fluoro exposures using various filters in each. Note the change in brightness and contrast in the left monitor and
determine if these images are automatically adjusted for the best brightness and contrast in each exposure.
4
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
