C-Arm Subsystem
3. Engage the C-Arm Orbital brake and verify that the C-Arm does not move.
4. Engage the Horizontal Cross-Arm brake and verify that the Cross-Arm does not move.
5. Engage the L-Arm brake and verify that the L-Arm does not move.
6. Engage the C-Arm wheel brake and then attempt to push the C-Arm. The wheels should not roll.
Wheels/Casters
Push the C-Arm and verify that the wheels roll smoothly, the casters turn freely and that the wheels are securely attached to the
casters. Visually inspect the wheels for damage.
Wig Wag
Release the Wig-Wag brake and verify that the forward mechanics move laterally
approximately
± 10° (20° total).
Flip Flop (Standard C-Arms only)
Release the Flip Flop brake and verify that the C-arm "flip-flops" through its entire range smoothly without roughness or vibration.
L-Rotation
Perform the following to verify radial rotation on Standard C-Arms and Super C-Arms:
1. On a standard C-Arm release the L-Arm brake and verify smooth rotation without roughness or vibration.
2. On a Super C-Arm release the L-Rotation brake and verify smooth rotation without roughness or vibration.
Orbital
Perform the following to verify orbital rotation for standard C-arms and Super C-arms:
1. On Standard C-arms, release the L-Arm brake and check C-arm rotation in the following positions:
17
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
