C-Arm Subsystem
a. Position the C-arm parallel with the floor and lock the L-Arm brake. Rotate the C-arm through its entire range. The C-arm
should rotate smoothly without vibration.
b. Position the C-arm on the opposite side and lock the L-Arm brake. Rotate the C-arm through its entire range. The C-arm
should rotate smoothly without vibration.
c. Position the C-arm vertical to the floor, lock the L-Arm brake and rotate the C-arm through its entire range. The C-arm
should rotate smoothly without vibration.
2. On Super C-arms, release the Flip Flop brake and check C-arm rotation in the following positions.
a. Position the C-arm parallel with the floor and lock the Flip-Flop brake. Rotate the C-arm through its entire range. The C-
arm should rotate smoothly without vibration.
b. Position the C-arm on the opposite side and lock the Flip-Flop brake. Rotate the C-arm through its entire range. The C-
arm should rotate smoothly without vibration.
c. Position the C-arm vertical to the floor, lock the Flip-Flop brake and rotate the C-arm through its entire range. The C-arm
should rotate smoothly without vibration.
Vertical Lift/
Boot the system, then press each vertical column motor switch through the full range of movement. During movement, press one
of the Fast Stop buttons. Verify that vertical movement stops, X-ray function is disabled, and the system shuts down. The vertical
lift should raise and lower fully and smoothly.
Horizontal Cross-Arm
Release the horizontal Cross-Arm brake and extend and retract the cross-arm. Verify that the cross-arm slides smoothly through
the housing without binding.
18
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
