Wig Wag Motion
Functional Tests
Loosen the Wig Wag brake and turn the Cross-Arm right or left 10 degrees on its Vertical Column mount. Make sure the Cross
Arm turns freely with the brake released. Make sure you can tighten the Wig Wag brake to secure the Cross Arm in any normal
lateral position.
CAUTION: Position Cross Arm housing facing straight ahead and set Wig Wag brake before moving C-Arm. Equipment
damage or personal injury may otherwise result.
Fault Isolation
If the Wig Wag brake does not work, inspect the Wig Wag brake mechanism, and replace any worn or broken parts.
If the Wig Wag motion does not work, look for loose or dragging brake parts. Follow the instructions in the Replacement chapter
of this manual.
4
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
