Wig Wag Motion
Adjustment
The Wig-Wag pivot mechanism does not require initial or periodic mantenance. The Wig-Wag brake is also adjusted at the
factory so that when the brake engages, the brake handle is approximately parallel to the cross-arm. However, after you replace
the brake, adjust as needed:
1. Remove Torx screw that retains the brake handle.
2. Remove the handle.
3. Adjust the brake acuator screw adjuster in
to make the brake engage earlier, or out to engage later.
4. Reinstall the handle onto the cross-arm in a position approximately parallel to the cross-arm with the brake engaged.
Torx Screw
Cross-Arm
Wig-Wag
Actuator
Handle
Wig-Wag Handle
approximately
parallel to Cross-Arm
Adjustment of the Wig-Wag Brake
5
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
