C-Arm Subsystem
Film Mode
If the C-Arm failed the Film Mode Performance Check, use the following fault isolation chart:
Note: The sections listed below are suggested starting points for your troubleshooting. It is likely that you will need to review
other sections also
Problem Probable Cause or Remedy
No anode whirring sound Refer to the Stator Control chapter of this manual.
No X-RAY ON indicator light Refer to the X-Ray ON and X-Ray DISABLE chapter of this manual.
No beeps when footswitch
pressed
Refer to the
kV Generation
and the
mA
Generation chapters sections of this manual.
Exposure unsuitable
Refer to the kV
Generation and mA Generation chapters of this manual.
Mechanical Movement
If the various checks for mechanical movement indicate a fault, refer to the applicable chapter for that movement, later in this
manual.
21
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
