L-Arm Motion
End Cap
Safety Bolt Access
3. Position L-Arm in normal vertical position as shown in the picture above. Do not set L-Arm brake at this time.
4. Position C vertically and set Flip Flop brake.
5. Rotate L-Arm slightly until hole for safety bolt becomes visible. Install and secure safety bolt as shown in the following
illustration. Secure the L-Arm brake.
6. Perform required maintenance, making sure to reinstall all removed items so that C is once again balanced.
7. Remove safety bolt.
8. Install L-Arm end cap and secure its mounting bolt. Be sure to install hole cover you removed in step 2.
9. Release L-Arm brake and check L-Arm for balanced and smooth rotation.
5
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
