Replacement
Electrical and Electronic Assemblies
This section provides replacement procedures for most electrical and electronic assemblies in the C-Arm.
Backplane
The Backplane mounts at the rear of the C-Arm card rack, where it provides an edge connector for the Fluoro Functions PCB, X-
ray Controller PCB, and High Voltage Supply Regulator PCB. As the following illustration shows, there are number of connectors
on the opposite side of the Backplane as well. Please refer to the Power Distribution section of this manual for more details.
Backplane
35
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
