Replacement
Follow these steps to replace the Backplane:
1. Turn off Workstation power and disconnect Workstation’s AC plug from facility’s AC outlet.
2. Remove C-Arm’s Rear Cover.
3. Remove card rack’s rear metal cover to expose PCBs inside rack. Retain screws.
4. Remove all three circuit card assemblies from card rack. Note position of each PCB.
5. Tag and unplug all connectors and ground wires from Backplane assembly.
6. Remove torx screws that secure Backplane assembly to card rack. Retain screws.
7. Remove Backplane assembly from card rack.
8. Install Backplane assembly to card rack assembly. Secure with screws you removed in step 6.
9. Install all connectors and ground wires you removed in step 5.
10. Install the three PCBs in card rack you removed in step 4.
11. Install card rack’s rear metal cover you removed in step 3.
12. Power up system and check for proper operation.
13. If system functions correctly, install C-Arm’s Rear Cover.
36
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
