Replacement
L-Arm and L-rotation Assembly
To separate the L-Arm from the Cross Arm, perform the following (see applicable pictures following):
WARNING: Verify that the L-Arm Gas Spring locking bolt is inserted. Failure to disable the L-Arm
may result in the gas spring spinning the L-Arm or Cross-Arm. This could result in
serious personal injury.
1. Pull back the Cross-Arm decals from the end of the Cross-Arm nearest the L-Arm.
2. Dislocate two roll pins from the Cross-Arm.
3. Separate the L-Arm from the Cross-Arm.
4. Reassemble in reverse order and replace the decals.
106
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Next Page
Loading...
