Replacement
1. Go to the point in this document that describes how to remove the Control Panel Assemblies.
WARNING: Verify that the L-Arm Gas Spring locking bolt is inserted. Failure to disable the L-Arm may
result in the gas spring spinning the L-Arm or Cross Arm. This could result in serious
personal injury.
2. Following the procedures, remove the Bearing Block Cover, Control Panel ASM., CPP and CPP I/O PCBs, Cross Arm and
Bearing Block.
3. Unscrew the Wig Wag Brake Actuator and slide the Floating Plate off.
4. Remove 4 hex bolts from the Fixed Plate.
5. Replace the Brake Pad.
120
Service
Periodic Maintenance
Contents
Schematics
Illustrated Parts
Installation
To Previous Page
Loading...
