7
Pre-load adjustment
1
Put the bike on a stand and loosen the screws in
the top fork crown that hold the fork legs.
NOTE!
On most MX-bikes you have take of the handle
bar off before you can unscrew the top cap.
Remove the adjustment wheel and the springs
and balls of the adjuster.
2
Unscrew the top cap, use tool (1860-01 or
1761-02).
Put a box under the front wheel so that the
springs are visible.
3
Remove the top cap from the damper rod extender.
Use a 17mm wrench, and tool (1860-01 or
1761-02).
Adjustment
wheel
Balls and
springs
Tool (1860-01)
Top cap
17 mm
wrench
Damper
rod assy
Damper rod
extender
Tool (1761-02)
To Next Page
Loading...
