4/8
SETTING SAG
Setting sag is a crucial part of setting your
bicycle since it affects the height of the bicy
-
cle and the fork angle. In the following chapter
we will describe two alternative ways of set
-
ting the sag.
Note!1
This procedure must be performed on a at surface. Do
not jump or bounce on your bicycle as it will result in an
inaccurate sag measurement.
Setting sag alternative 1:
Auto-sag setup
The auto-sag feature simplies the air pres
-
sure adjustment and automatically determines
the correct amount of sag.
1
Use a shock absorber pump and ll up the
shock absorber to 250 psi.
2
Dressed in full riding gear assume normal rid
-
ing position on the bicycle.
3
Release the air pressure until air ow stops.
4
Cycle the shock a couple of times to even out
the pressure between the air chambers.
5
If this sag is not suitable for your riding style
see section Setting sag alternative 2 Manual
sag setup.
1
2
4
3
250 psi
To Next Page
Loading...
