Ohmic instruments UPM-DT-10PA - Calibration Interval

i
CALIBRATION INTERVAL, WARNINGS, CAUTIONS, NOTICES ........................................................... i
INTRODUCTION .................................................................................................................................................... 1
TEST SETUP ........................................................................................................................................................... 2
METER LAYOUT .................................................................................................................................................... 7
TESTING ................................................................................................................................................................. 10
PRINTING AND COMMUNICATIONS ........................................................................................................... 11
TROUBLESHOOTING ........................................................................................................................................ 12
MANUAL REVISIONS ......................................................................................................................................... 13
LIMITED WARRANTY......................................................................................................................................... 13
SPECIFICATIONS ................................................................................................................................................ 14
NOTES ..................................................................................................................................................................... 15
UPM-DT-xPA SERIES ULTRASOUND WATTMETER
TABLE OF CONTENTS
WARNING - USERS
The UPM-DT-xPA Series is for use by
skilled technical personnel only.
CALIBRATION INTERVAL
To ensure the accuracy of the UPM-DT-xPA
Series, Ohmic Instruments recommends that it
be calibrated at least once every 12 months.
Calibration must be done by qualified personnel.
Contact Ohmic Instruments for calibration.