Oki B431L6

4. ADJUSTMENT
Oki Data CONFIDENTIAL
44983601TH Rev.1
4-7 /
Category
Operation panel display
Default
value
Function
* Only English is supported for panel
display
Setting item
(Uppercase)
Setting item
(Lowercase)
PERSONALITY PCL ENABLE
DISABLE
*
ChangethedefaultofSupportPDLLanguage
for each destination.
ThePDLLanguagethatisDisableinthis
MWNUisnotdisplayedontheOPMENUof
EMULATEandAdministratorMENUofuser
menu.(About"PCLXL",becauseitdoesnot
havespeciedmenu,noappearancechange
is shown even at Disable.)
AsreceivingtheprintingdataofDisablePDL
Language,itdisplaysINVALIDDATAand
discards the received data.
InthecasethatsettheJapanOriented"IBM
PPRIIIXL"and"EPSONFX"asEnable,the
operation is not guaranteed.
"PS3EMU"isonlydisplayedatPSE
implementation.
ItmeansReadOnlyWhile"PCL"cannotbe
setasDisable.(Normally,itisusedbyEnable.
Even set as Disable it still process received
data.
DefaultValue:ForJapanOrientedequipment
sets"IBMPPR"and"EPSONFX"asDisable,
yet"ESC/P"asEnable.ForNonJapan
Orientedequipmentsets"IBMPPR"and
"EPSONFX"asEnable,yet"ESC/P"as
Disable.
IBMPPRIIIXL ENABLE
DISABLE
*E
*J
EPSONFX ENABLE
DISABLE
*E
*J
ESC/P ENABLE
DISABLE
*J
*E
PS3EMULATION ENABLE
DISABLE
*
PCLXL ENABLE
DISABLE
*
ROLLINGASCII ROLLINGASCII EXECUTE
SetPRINTINGRollingASCIIascontinuously
printing.
SetRollingASCIIPatenascontinuously
printing.
Press"ENTER"switchatthismenudisplaying.
AfterEXECUTEdisplayedinthelowercase,
press"ENTER"switchtosettletheexecution.
Press"ON-LINE"switchtoinitializeandthen
continuously printing is available.
Fortheterminationofthismode,itisto
press"ON-LINE"switchandwaitforprinting
stopped,andthenshutdownpowerorpress
"CANCEL"switch.
After this operation it can not return to any
other maintenance mode.
DOTSHIFT
(*1)
TRAY1 -2.0MILLIMETER
~
-1.5MILLIMETER
-1.0MILLIMETER
-0.5MILLIMETER
0.0MILLIMETER
+0.5MILLIMETER
~
+2.0MILLIMETER
*
Set landscape dot Shift of Tray 1 while printing.
Inthisarea,evenEEPROMRESETsuchas
ROMVer.UPisnotinitialized.
TRAY2 -2.0MILLIMETER
~
-1.0MILLIMETER
-0.5MILLIMETER
0.0MILLIMETER
+0.5MILLIMETER
~
+2.0MILLIMETER
*
Set landscape dot Shift of Tray 1 while printing.
ItemisdisplayedevenTray2isnot
implemented.
Inthisarea,evenEEPROMRESETsuchas
ROMVer.UPisnotinitialized.