Oki C332dn - RKA 5 Setup

Product Information
Setting up OKI C332dn Color Laser Printer
1.3 RKA 5
To install the OKI C332dn color laser printer with the RKA 5 follow these steps.
1. Unpack the printer and the cables.
2. Connect the power cable.
3. Connect the USB cable with the printer and the RKA 5.
4. Switch on the printer.
5. Use the jog wheel to navigate to "Setup > Interfaces > Printer".
Fig. 4 – Select "Setup" Fig. 5 - Select "Interfaces"
Fig. 6 – Select "Printer" Fig. 7 – Select "Laser" as printer type
6. Choose the printer type “Laser” and click on the <Save> button. There is no confirmation that the data was
saved.
7. Click <Back> and check again that printer type is indeed “Laser”.
8. Now you can use the printer with the RKA 5.
Contact us at
Anton Paar ProveTec GmbH
Ludwig-Erhard-Ring 13
15827 Blankenfelde-Mahlow – Germany
Phone: +49 (0)33708 56-300
Fax: +49 (0)33708 56-556
E-Mail: info.provetec@anton-paar.com
Website: www.anton-paar.com
www.anton-paar.com | Created by Pütz, Dunja on 16.08.2017 | XPTIE008EN-A_ProdInfo_OKI_C332dn.docx page 3 of 3