Oki MB760 - Service UI; Operation Procedure in Adjustment Mode (05); Operation Procedure in Setting Mode (08); Assist Mode (3 C)

45641001TH Rev.1
3-3 /
Oki Data CONFIDENTIAL
• Testmode(03)
Refer to

P.3-7“3.3Inputcheck(Testmode03)”and&P.3-9“3.4Outputcheck(testmode
03)”.
• Testprintmode(04)
Refer to

P.3-9“3.5Testprintmode(testmode04)”.
• Adjustmentmode(05)
Refer to

P.3-10“3.6OperationProcedureinAdjustmentMode(05)”,

P.3-12“3.7Test
printpatterninAdjustmentMode(05)”,and“Appendix”-“AdjustmentCode(05).”
Notes:
Whenthe powershould beturned OFF, besure toshut downtheequipmentbypressing
the [ON/OFF] button for a few seconds.
Remarks:
• In“RAM”,theSRAMoftheboardinwhichthedataofeachcodeisstoredisindicated.“PU”
standsforthePUboardand“SYS”standsfortheSYSboard.
• Settingmode(08)
Refer to

P.3-13“3.8OperationProcedureinSettingMode(08)”and“Appendix”-“Setting
Code(08).”
Notes:
Whenthe powershould beturned OFF, besure toshut downtheequipmentbypressing
the [ON/OFF] button for a few seconds.
Remarks:
• In“RAM”,theSRAMoftheboardinwhichthedataofeachcodeisstoredisindicated.“PU”
standsforthePUboard,“SYS”,“NIC”or“UTY”standsfortheSYSboard.
• Maintenancemode(68)
Referto“5.2Maintenancemenufunctions”intheHardwareGuide.
• Assistmode(3C)
Refer to

P.3-15“3.9AssistMode(3C)”.
• HDDassistmode(4C)
Refer to

P.3-18“3.10HDDAssistMode(4C)”.
• Filesystemrecoverymode(5C)
Refer to

P.3-23“3.11FileSystemRecoveryMode(5C)”.
• SRAMclearmode(6C)
Refer to

P.3-27“3.12SRAMClearMode(6C)”.
• Listprintmode(9S)
Refer to

P.3-29“3.13Listprintmode(9S)”.
• Firmwareupdatemode(49/89)
Refer to

P.8-1“8.FIRMWAREUPDATING”.