To Next Page

To Previous Page

45641001TH Rev.1

iv /

Oki Data CONFIDENTIAL

GENERAL PRECAUTIONS REGARDING THE SERVICE FOR THIS EQUIPMENT

The installation and service shall be done by a qualiﬁed service technician.

1. Transportation/Installation

- Whentransporting/installingtheequipment,employtwoormorepersonsandbesure

toholdthepositionsasshown in thefigure.The equipmentisquiteheavyandweighs

approximately55kg(121.23lb.) (includingthe nisher),thereforepayfullattentionwhen

handling it.

- Besurenottoholdthemovablepartsorunits(e.g.thecontrolpanel,ADUorRADF)when

transportingtheequipment.

- BesuretouseadedicatedoutletwithAC110V/15A,120V/12A,220-240V/8Aforitspower

source.

- Theequipmentmustbegroundedforsafety.

- Selectasuitableplaceforinstallation.Avoidexcessiveheat,highhumidity,dust,vibration

and direct sunlight.

- Toinsureadequateworkingspaceforthecopyingoperation,keepaminimumclearanceof

30cm(12”)ontheleft,30cm(12”)ontherightand60cm(24”)ontherear.

- Theequipmentshallbeinstallednearthesocketoutletandshallbeaccessible.

- Be sure to ﬁx and plug in the power cable securely after the installation so that no one trips

over it.

- If the unpackingplace and where the equipment is to be installed differ, perform image

qualityadjustment(automaticgammaadjustment)accordingtothetemperatureand

humidity of the place of installation and the paper to be used.

- Iftheequipmenthascasters,lockthemaftertheinstallation.

Oki MB760 Service Manual

Other manuals for Oki MB760